12/14/2023 0 Comments Audio bar out of sync with tv![]() ![]() ![]() Reverse the ends - the one that went to the TV goes into the IgniteTV box and vice versa.Īre you using the HDMI cable that Rogers supplied? For example, if you set the sound bar to "stereo" for decoding instead of DPL, then you'll probably hear no difference at all between the DD & Stereo output for the Rogers box for a channel like Here are my suggestions: As discussed in the above link, CP24 is one of the channels that is still "improperly encoded", hence you'll hear a difference between DD & Stereo, but it's not because of the Stereo setting in the Rogers box. What you may be hearing when you say there is a large difference, is similar to listening to the LF & RF speakers instead the centre speaker. Note that Rogers has issues regarding appropriate surround sound as discussed in the following detailed post: The "proper" decoder should be Dolby Pro Logic II or similar. What you're probably hearing is the difference when two different decoder methods are being used by the bar. There should be very little difference between the DD & Stereo settings in a Sound Bar like yours on properly encoded programming. The workaround for that is again to use the stereo setting and invoke DPLII in the Re/ the note about swapping to stereo, this is not a good fix.ġ.Does switching to Stereo eliminate the lag issue?Ģ. There is a totally different issue which has been discussed regarding the lack of proper DD5.1 on recorded programming on IgniteTV, however, that is a totally separate subject discussed in its own thread. I'm not sure this is a Rogers issue completely since I don't recall hearing any issues regarding audio delays with an AVR, rather it appears to be limited to certain makes/models of TV, which would indicate that it's a TV manufacturer issue/incompatibility. You would need a very good DD5.1 mix on a programme with lots of rear channel audio and discrete signals to the LR & RR speakers to hear any difference.Ģ. If you're listening via an AVR (audio video receiver) then there can be a slight difference when listening to DD5.1 signals (more discrete rear channel audio), but often there is no perceivable difference there either if the AVR invokes a surround sound mode like Dolby Pro Logic II. If you're listing to your TV speakers, the stereo setting is perfectly adequate and you shouldn't hear any difference between the various audio output settings on the Rogers box. When is Rogers going to correct this issue?ġ. ![]() Try resetting your modem or router and see if the problem is fixed.Does work but we shouldn’t have to change setting to Stereo when there better options available.Ģ. This could be caused by a poor internet connection. If the problem only happens while watching streaming videos, check your internet connection.If you are already watching the app on a game console, try downloading the app to your smart TV or a streaming box and see if the problem happens on a different device. If the problem is only happening on one streaming app, try downloading that app to a different device, such as a game console or streaming box (i.e, Roku, Firestick TV).Contact the creator or streaming service to let them know. If the problem is only happening with one streaming video, most likely the audio and video are not properly mixed.Try again later and see if the problem has been fixed. Contact your cable or satellite provider to let them know. If the problem is only happening on one TV channel, the problem is most likely with the channel itself.See if the problem is happening on all videos and all apps. If the problem starts happening while watching a streaming video, try watching a different video or watching a different streaming app. If the problem starts happening while you are watching TV, try changing the channel to see if the problem is happening on other channels.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |